Microplex LOGIJET T4 - Page 99

Panel Functions 99
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
Peripheral device selection:
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Engine ]
[Printspeed ]
& & &
[Service Mode ]
[Dot-Test ]
& & &
[Periph. Device ]
[TearOff Edge ]
& & &
[Cutter ]
[Saved! ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key
until [Engine ] is displayed.
Press the NEXT or PREVIOUS key
until [Service Mode ] is displayed.
Press the NEXT or PREVIOUS key
until [Periph. Device ] is displayed.
Press the NEXT or PREVIOUS key
until the desired peripheral device is
displayed.
The cutter (option) is selected.
Turn the printer ON LINE again:
Press the ENTER key longer than
2
seconds.