Handling of Consumables 23
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
5. Handling of Consumables
Pay attention to the following safety instructions and the instructions
listed in section 1.4, too!
Safety instructions:
- The cutter (optional device of your printer) can cause injuries if the
printer is operated incorrectly.
- There is a danger of fingers, hair, clothing, jewellery etc. being
drawn into the machine in the vicinity of the material transport unit.
- Be careful when operating equipment with opened cover hoods
(setting-up work or service). Rotating parts can cause injury, and it
is possible for hair, clothing, jewellery, etc. to be caught in the
machinery.
- Print material should only be inserted and changed by specially
instructed personnel.
!
For thermal direct printing it is not allowed to load a ribbon to avoid
damaging the printhead. Make sure your settings using the control
panel and display respectively via interface (see chapter 6 and 7) fit
to the printer implementation (ribbon inserted /not inserted).
Ribbon and material should only be inserted/exchanged by specially
instructed personnel.
To Next Page
Loading...