46 Control Panel
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
6. Control Panel
6.1. Attaching the Printer to a Computer
1. Make sure the printer, computer, and any other attached devices
are turned off and unplugged.
2. Use a proper interface line to connect the printer to the computer or to
attach the printer to the network.
The printers LOGIJET T4 /T6 /RFID are provided with several interfaces; see
figure 2.4.b and chapter 12 Specifications for more information.
6.2. Turning on the Printer
!
First, please notice the instructions given in chapter 5 Handling of
Consumables.
1. Plug one end of the printer power cord into the socket at the back of the
printer and the other end into a properly grounded outlet.
2. Turn on the printer. The power switch is located at the rear side of the
printer (see section 2.4 Printer Components).
As soon as the printer’s warm up phase is finished the printer goes into
the ON LINE mode. A status message and the name of the printer are
displayed.
To Next Page
Loading...