Microplex LOGIJET T4 - Print Speed Adjustment

84 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.22. Print Speed Adjustment
This function is used to change the print speed (adaptation to the
actual used materials, e.g. to optimize the contrast of the printout).
The setting range for the print speed is 2 inch/s to 6 inch/s.
OFFL.
MENU
NEXT
ENTER
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu level 1 ]
& & &
[Engine ]
[Printspeed ]
[ 6 inch/s ]
& & &
[ 4 inch/s ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key
until [Engine ] is displayed.
The currently set value is displayed.
Press the NEXT or PREVIOUS key
until the desired value is displayed.
Here the print speed is reduced to 4
inch/s.
In addition this new value can be
saved as setup value (using the
ENTER key).
After this decision turn the printer
ON LINE again: Press the ENTER key
longer than 2 seconds.