Microplex LOGIJET T4 - Contrast (Density) Setting

Panel Functions 85
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.23. Contrast (Density) Setting
Using this function the print density (contrast) of the printed characters
can be changed.
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Engine ]
[Printspeed ]
& & &
[Contrast ]
[Contrast: 85 % ]
& & &
[Contrast: 60 % ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[Contrast ] is displayed.
The currently set value is displayed.
Press the NEXT or PREVIOUS key to
change the contrast.
Values from 10% to 120% are
settable *.
The contrast is reduced to 60 % (the
density is decreased).
In addition this new value can be
saved as setup value (using the ENTER
key).
After this decision turn the printer ON
LINE again: Press the ENTER key
longer than 2 seconds.
* Note: Please consider that using high contrast values (more than 100%) can
result in a reduced lifetime of the printhead.