62 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.4. Material Width Adjustment (Paper Width)
The paper width (print width) has to be adjusted with this function
according to the currently used format.
OFFL.
MENU
NEXT
ENTER
ENTER
NEXT
ENTER
ENTER
NEXT
ENTER
ESC
ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Paper Menu ]
[Paper Size ]
[Page Length ]
& & &
[Paper Width ]
[in mm ]
& & &
[Digit4 108.4]
& & &
[Digit1 108.0]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The MENU key gives the user access to the menu
structure.
Press the NEXT or PREVIOUS key until
[Paper Menu ] is displayed.
Press the ENTER key to select the paper menu.
Press the ENTER key to select the paper size menu.
Press the NEXT or PREVIOUS key until
[Paper Width ] is displayed.
Press the ENTER key to adjust the format width to
the paper width.
mm = currently selected measuring unit.
(Alternative the units inch or dot can be chosen
with NEXT or PREVIOUS).
Pressing the VAL+ or VAL- key changes the value
of the current digit (Digit4 = left position, in this
example: 1). Pressing the NEXT key moves you to
the next digit (the PREVIOUS key combination
moves you back, if need be).
The format width (paper width) is changed to
108.0 mm.
In addition this new value can be saved as setup
value (using the ENTER key).
After this decision turn the printer ON LINE again:
Press the ENTER key longer than 2 seconds.
To Next Page
Loading...