Microplex LOGIJET T4 - Page 151

Troubleshooting 151
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
Panel display Remedies
[Paper Jam ! ]
or
[Punch Error ]
or
[Sync.Mark Error ]
These error messages indicate a paper jam:
- remove the jammed consumables
(labels sticking together e.g.)
- reload the consumables (paper)
(see chapter 5)
- perform the basic operations
(see chapter 4)
- For further information about the
avoiding of paper jams please take
notice of section 10.3 Incorrect Media
Transport
[HeadNot Found! ] - the printhead is not connected or faulty.
[Head defectiv! ] - the printhead is defective. A new printhead
has to be installed.
[High Head Temp. ] The printhead temperature is too high.
- make sure the consumables have been
loaded correctly
(compare section 5.2 and 5.3)
[Head Life End! ] - a new printhead has to be installed
Note:
Information about error messages referring to the RFID — functions of the
printer can be found in section 8.6.
If the remedies above are not successful, please call a MICROPLEX
authorized service engineer.