Microplex LOGIJET T4 - Page 156

156 Troubleshooting
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
Panel display Remedies
[Dispen.NotFound ] The optional dispenser is selected, but not
connected or defective.
- make sure the dispenser is installed correctly.
Also, see section 7.29 Peripheral Device
Activation
- Unselect the dispenser, if the dispenser was
deinstalled. See section 7.29
[Dispenser Error ] An error occured during dispenser operation.
- check for a paper jam.
Remove the jammed paper.
- reload the consumables (paper)
[CutterNotFound! ] The optional cutter is selected, but not
connected or defective.
- make sure the cutter is installed correctly.
Also, see section 7.29 Peripheral Device
Activation (Tear Off Edge, Cutter)
- Unselect the cutter, if the cutter was
deinstalled. See section 7.29
[Cutter Error! ] An error occured during cutter operation.
- check for a paper jam.
Remove the jammed paper.
- reload the consumables (paper)
If the remedies above are not successful, please call a MICROPLEX
authorized service engineer.