Microplex LOGIJET T4 - Page 39

Handling of Consumables 39
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
B) Decreasing the ribbon tension
If narrow ribbon is used (ribbon widths of less than 2”, e.g.), the
printer might have a problem feeding the material.
Moreover, the ribbon maybe difficult to be removed caused by a
high ribbon tension. Excessive values of ribbon tension may
cause shapechanges of the ribbon, too.
To solve this problems the ribbon tension has to be decreased:
1. Push the adjusting ring of the ribbon rewind shaft towards
the ribbon roll. See figure 5.3.2.a.
2. Then turn the adjusting ring of the ribbon rewind shaft
counterclockwise to decrease the ribbon tension, while
you hold the ribbon roll with the other hand.
3. Push the adjusting ring of the ribbon supply shaft towards
the ribbon roll. See figure 5.3.2.b.
4. Then turn the adjusting ring of the ribbon supply shaft
counterclockwise to decrease the ribbon tension, while
you hold the ribbon roll with the other hand.
5. Check that the ribbon has no folds and is running straight.
Optimize your adjustment of the ribbon tension, if need be.
!
Check to see that slack and wrinkles on the ribbon are removed
completely. Do not be afraid to ’waste’ a little extra ribbon to
ensure the ribbon is running correctly and wrinkle-free.