54 Control Panel
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
Functions / Changing of function values:
NEXT
ESC
+
NEXT
VAL+
ESC
+
VAL+
Within one function the value can be changed by pressing the NEXT
key or the combination of ESC + NEXT (= PREVIOUS).
In case of a multi-digit function value pressing the NEXT key switches
to the next position (digit) of the function value.
Pressing the key combination ESC + NEXT (= PREVIOUS) switches to
the previous digit of the function value.
Please note: If you press the ESC key although the absolute left digit
of the function value is still arrived, the changing
procedure will be cancelled and this moves you to the
next menu level above.
If you press the ENTER key although the absolute right
digit (digit 1) of the function value is still arrived, the
currently displayed function value is stored.
In case of a multi-digit function value the value of the currently chosen
digit can be changed by pressing the VAL+ key or the key
combination ESC + VAL+ (= VAL-).
ENTER
[Save as Setup?]
ENTER
ESC
By pressing the ENTER key the function values currently displayed
are confirmed respectively the selected function is activated (the
changes are saved until the next printer power off; this kind of
saving is called temporary).
After this you have to decide, if you want to save the changes
permanent (Save as setup).
To select such changes permanently, the user must press the
ENTER key one more time. These permanent changes in printer
configuration are active each time the printer is turned on again.
If the ESC key is pressed instead, the changes are only stored
temporary (not saved as setup).
(This key takes the user to the respective previous menu level).
To Next Page
Loading...