Microtek ArtixScan 120tf Reference Manual

136 ScanWizard Pro TX for Mac & PC
Appendix D: Photoshop Color Settings
To ensure color consistency between Photoshop 5.0 (or later) and ScanWizard
Pro TX, the color settings (CMS engines, ICC RGB monitor profile, and ICC
CMYK printer profile) for both software programs should be identical.
To set Photoshop color settings:
1. Install ScanWizard Pro TX first.
2. When you install ScanWizard Pro, the Installer program lets you choose the
ICC profiles to match with your monitor display and printer types.
Once you have chosen display and printer ICC profiles in ScanWizard Pro
TX, install Photoshop 5.0 (or later), and choose the same profiles.
For example, in ScanWizard Pro TX you choose “Generic P22 1.8 Gamma
Monitor” as the display item, and “Light GCR 300 UCR CMYK Japan Std.
Proofing” as the CMYK destination item.
NOTE
::
::
: The Photoshop default setting for display monitor is sRGB. If you have
selected sRGB as your Display setting in the ScanWizard Pro TX Color Matching,
there is not need for you to perform the monitor calibration and RGB setup
discussed in the following sections.

Microtek ArtixScan 120tf Specifications

Power

voltage	AC 90V to 264V, 47-63 Hz

Operating Environment

operating temperature	50° to 95°F (10° to 35°C)
relative humidity	20% to 80%

Scanning Specifications

scanning area	6 x 9 cm Max., 6 x 7 cm, 6 x 6 cm, 6 x 4.5 cm, 25 x 38 mm
resolution optical	4, 000 dpi x 4, 000 dpi
resolution interpolated	16, 000 dpi x 16, 000 dpi

Interfaces

firewire ports	Two
scsi ports	Two
transmission speed firewire	4 Mbytes/s
transmission speed scsi	2 Mbytes/s

Weight and Dimensions

dimensions	19.8" x 10.8" x 5.5" (504 x 274 x 142 mm)
weight	17.6 lb (8 kg)