Microtek ArtixScan 120tf Reference Manual

Reference: The Preview window 11
Scanner Driver Manager (Macintosh only)
The Scanner Driver Manager keeps track of the scanners being used on your
system and their corresponding bus/ID numbers. By keeping a record of this
information, the Scanner Driver Manager allows ScanWizard Pro TX to start up
faster, as searching for devices from other buses is no longer required.
When ScanWizard Pro TX is run for the first time right after installation, all pre-
connected powered-on scanners and corresponding SCSI/USB ID or SCSI/USB
bus are automatically detected and added to the Scanner List of the Scanner
Driver Manager dialog box.
Find Scanners button
Whenever you change the SCSI/USB ID or SCSI/USB bus of a scanner or
increase the number of connected scanners while ScanWizard Pro TX is
running, you need to add the new devices to the list by following the steps below.
1. Go to the Scanner menu in the Preview window, and choose Scanner Driver
Manager. A dialog box will appear showing the current scanner list and the
corresponding SCSI or USB bus/ID numbers of the scanners.
2. Click the Find Scanners button. Observe the newly found scanners being
appended to the scanner list.
NOTE
::
::
: Any previously listed scanner which is inactive (not turned on or removed
from the system) will remain in the list but is shown with a question mark (?).
3. Click the Close button to close the dialog box.

Microtek ArtixScan 120tf Specifications

Power

voltage	AC 90V to 264V, 47-63 Hz

Operating Environment

operating temperature	50° to 95°F (10° to 35°C)
relative humidity	20% to 80%

Scanning Specifications

scanning area	6 x 9 cm Max., 6 x 7 cm, 6 x 6 cm, 6 x 4.5 cm, 25 x 38 mm
resolution optical	4, 000 dpi x 4, 000 dpi
resolution interpolated	16, 000 dpi x 16, 000 dpi

Interfaces

firewire ports	Two
scsi ports	Two
transmission speed firewire	4 Mbytes/s
transmission speed scsi	2 Mbytes/s

Weight and Dimensions

dimensions	19.8" x 10.8" x 5.5" (504 x 274 x 142 mm)
weight	17.6 lb (8 kg)