Microtek ArtixScan 120tf Reference Manual

12 Microtek ScanWizard Pro TX for Mac & PC
Remove Scanner button
To remove a listed scanner from the Scanner List, do the following:
1. Choose Scanner Driver Manager from the Scanner menu.
2. Choose the scanner you wish to be removed from the list.
3. Click the RemoveScanner button.
4. Click the Close button to close the dialog box.
Update List button
The Update List button is used to refresh your scanner list. For instance, you may
have three scanners on your system, with two of them currently turned off.
When you choose Scanner Driver Manager, the dialog box may show a question
mark in front of the two scanners that have been turned off. In this case, simply
click the Update List button, and the scanner list will be refreshed and show only
the connected one on the list.
Clicking the Update List button produces faster results than clicking the “Find
Scanners” button. Update List simply searches the scanner models already on
your list, while Find Scanners looks through all the buses and does a more
thorough search of the system before giving you the results.
Scanner Probe button
See Scanner Probe command in the previous section.

Microtek ArtixScan 120tf Specifications

Power

voltage	AC 90V to 264V, 47-63 Hz

Operating Environment

operating temperature	50° to 95°F (10° to 35°C)
relative humidity	20% to 80%

Scanning Specifications

scanning area	6 x 9 cm Max., 6 x 7 cm, 6 x 6 cm, 6 x 4.5 cm, 25 x 38 mm
resolution optical	4, 000 dpi x 4, 000 dpi
resolution interpolated	16, 000 dpi x 16, 000 dpi

Interfaces

firewire ports	Two
scsi ports	Two
transmission speed firewire	4 Mbytes/s
transmission speed scsi	2 Mbytes/s

Weight and Dimensions

dimensions	19.8" x 10.8" x 5.5" (504 x 274 x 142 mm)
weight	17.6 lb (8 kg)