License and Warranty Provisions
This manual and the product described in it have been protected internationally by copyright and other applicable laws
with all rights reserved. You may not remove or conceal any trademark, patent or copyright notice appearing on the
product or this manual. Microtest remains the sole owner of the software programs that are part of this product. Microtest
grants you a nonexclusive license to use these software programs. This license is for a single user only. You may not
make any copies of the software other than as a backup copy for your own use. You may not sell, rent, lease, lend,
distribute or otherwise transfer copies of the software or this manual to others, except that you may permanently transfer
all copies of the software in your possession (including any backups) and all related materials as a set to another person
who accepts the terms of this license agreement. You may not modify, transcribe, translate, decompile, reverse engineer
or reverse assemble the software or create any derivative works from it. Microtest may terminate this license at any time
without notice if you breach any of these terms. If any provision of this license is held to be unenforceable or contrary
to any applicable law, the validity of the remaining provisions shall not be affected.
Microtest’s Limited Warranty
Microtest warrants, for your benefit alone, that the hardware product described in this manual will be free from defects in
materials and workmanship for a period of one (1) year in the case of whole units and ninety (90) days for board level
units and accessories after the product is delivered. Microtest further warrants, for your benefit alone, that the software
product in this manual will operate substantially in accordance with the functional specifications set forth in this manual
for a period of ninety (90) days after the product is delivered. Microtest is not obligated to repair or otherwise remedy
any nonconformity or defect in its software product if you have made any changes whatsoever to the product, if the
product has been misused or damaged in any respect, or if you have not reported to Microtest the existence and nature
of the nonconformity or defect promptly upon discovery. Your sole and exclusive remedy in the event of a defect or
nonconformity is to return the product to the place of purchase for repair or replacement, at Microtest’s discretion. In lieu
of replacing software products, Microtest may, in its discretion, refund the amount paid as the license fee for the defective
or nonconforming software module. Contact your dealer for instructions on returning defective products.
EXCEPT FOR THE WARRANTIES SET FORTH ABOVE, MICROTEST’S PRODUCTS, AND THE SOFTWARE CON-
TAINED THEREIN, ARE LICENSED “AS IS,” AND MICROTEST DISCLAIMS ANY AND ALL OTHER WARRANTIES,
WHETHER EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES AS TO THE SUITABIL-
ITY OR MERCHANTABLILITY OR FITNESS FOR ANY PARTICULAR PURPOSE OF ANY PRODUCTS OR PROGRAMS
FURNISHED HEREUNDER. IN NO EVENT SHALL MICROTEST BE LIABLE FOR ANY LOSS OF ANTICIPATED PROF-
ITS, BENEFITS, USE OR DATA, OR ANY INCIDENTAL, EXEMPLARY, SPECIAL, OR CONSEQUENTIAL DAMAGES,
REGARDLESS OF WHETHER MICROTEST WAS ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES
DO NOT ALLOW THE LIMITATION OR EXCLUSION OF LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAM-
AGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
U.S. GOVERNMENT RESTRICTED RIGHTS NOTICE
The software programs that are part of this product are provided with Restricted Rights in accordance with 48 CFR §
52.227-14 and may not be used, reproduced, or disclosed by the Government except that this software may be (1) used or
copied for use in or with the computer or computers for which it was acquired, including use at any Government installation
to which such computer or computers may be transferred; (2) used or copied for use in a backup computer if any computer
for which it was acquired is inoperative; (3) reproduced for safekeeping (archives) or backup purposes; (4) modified, adapted,
or combined with other computer software, provided that the modified, combined, or adapted portions of the derivative
software incorporating restricted computer software are made subject to the same restricted rights; (5) disclosed to and
reproduced for use by support service Contractors in accordance with subparagraphs (1) through (4) of this clause, pro-
vided the Government makes such disclosure or reproduction subject to these restricted rights; and (6) used or copied for
use in or transferred to a replacement computer. Notwithstanding the foregoing, if this computer software is published
copyrighted computer software, it is licensed to the Government, without disclosure prohibitions, with the minimum rights set
forth in this clause. Any other rights or limitations regarding the use, duplication, or disclosure of this computer software are
to be expressly stated in, or incorporated in, the contract under which it is provided to the Government. This Notice shall be
marked on any reproduction of this computer software, in whole or in part.
Copyright © 1999, Microtest, Inc. All rights reserved. No part of this document may be photocopied, reproduced, or translated to
another language without the prior written consent of Microtest, Inc.
Microtest, Inc. makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of
merchantability and fitness for a particular purpose. Microtest, Inc. shall not be liable for errors contained herein or for incidental
consequential damages in connection with the furnishing, performance or use of this material.
Warning: This manual and the software described herein are protected by United States Copyright law (Title 17 United States
code). Unauthorized reproduction and/or sales may result in imprisonment for up to one year and fines of up to $10,000 (17 USC
506). Copyright violators may also be subject to civil liability.
The information in this document and the software are subject to change without notice.