Microtest OMNIScanner2 User Manual

2 - 3
OMNIScanner User Guide
The following sections provide detail on the certification process.
Setting the Reference
A reference must be set when OMNI Scanner and OMNI Remote are used
as a set for the first time. After the initial reference setting, the process
should be repeated periodically to ensure unit verification. OMNI Scanner
stores reference data for up to 5 remote units by serial number.
1. To set the reference, connect OMNI Scanner and OMNI Remote using the
Link Adapter and Channel Adapter* supplied with the scanner (as shown).
*Use the Set Reference Adapter with OMNIScanner LT.
2. Turn OMNI Scanner on.
3. Press (Setup).
4. Select Set Reference.
5. On finding OMNI Remote , the scanner reports:
Acquiring Reference Data. A gauge will indicate
the progress.
6. Once the reference values has been recorded, OMNI Scanner displays
the REMOTE INFO screen.
7. Press ESC to return to OMNI Scanner ’s SETUP screen.

Microtest OMNIScanner2 Specifications

General

Brand	Microtest
Model	OMNIScanner2
Category	Scanner
Language	English