Microtest OMNIScanner2 User Manual

2 - 7
OMNIScanner User Guide
selected Save Option.
Press (Save) to save the test results to OMNI Scanner’s internal
memory.
Press (Save with Graphs) to save the test results with their graphs
to OMNI Scanner’s internal memory. Note: Saving graphs will reduce the
number of Autotests that can be stored.
Press (Save to MMC) to save the test results to the
MultiMediaCard. (OMNI Scanner2 only.)
Press (Save with Graphs to MMC) to save the test results with their
graphs to the MultiMediaCard. (OMNI Scanner2 only.) Note: Saving graphs
will reduce the number of Autotests that can be stored.
8. Press ESC to return to the Autotest screen without saving the Autotest.
9. To run the next Autotest press the key.
Viewing Twisted Pair Autotest Results
This viewing option is only available immediately after the Autotest was
performed.
To view stored test results at a later time, press the (Results)
function key located in the Project screen. (See Chapter 7 - Results for
more information.)
Note: The list of tests varies depending on the kind of Autotest that was
performed.
1. To view detailed results of all the tests that were performed during
Autotest, highlight a specific test in the Autotest screen using the é or ê
and press ENTER.
2. Use the ç or è to quickly browse through all other detailed test result
screens and their results.
All Tests that can run during Autotest are displayed on the next page. (See
Chapter 5 - Measurements for detailed descriptions of each available test.)

Microtest OMNIScanner2 Specifications

General

Brand	Microtest
Model	OMNIScanner2
Category	Scanner
Language	English