OM-267357 Page 40
SECTION 9 − ASSIGNMENT MANAGEMENT
Welding-related hazards are present when using the welding training system. Read the welding power source and wire feeder Owner’s
Manuals and labels carefully for more information on arc welding hazards. Also read American National Standard Z49.1, Safety in
Welding, Cutting, and Allied Processes, from American Welding Society (www.aws.org). Operators must be trained on the proper use
of this equipment before using the equipment to train others.
9-1. Administration Mode
Administration
mode is only available to users designated as instructors. Select either MIG/Flux Cored or Stick, then touch MIG/FC Assignment Mgmt
or Stick Assignment Mgmt to begin.
Use Assignment Management screen to create new assignments, edit/modify assignments, delete assignments, and select (hide/show) which
assignments are displayed. The new assignment can be tailored to meet the specific training needs of the students by modifying the parameters for
Name, Joint Design, Base Metals, Filler Metals/Shielding, Position/Electrical Characteristics, Technique, Preheat/Postweld Heat Treatment, Welding
Procedure, and Completion Criteria.
Figure 9-1. Administration Mode Screen
Notes
Register to Receive IMPORTANT Alerts
for FREE LiveArc Software Upgrades
MillerWelds.com/register
Serial Number Sticker
To Next Page
Loading...
