5-8
Error message Cause Corrective measure
USB device initialization failure.
• Turn off the power to the device an
turn it on after a while.
• If the same error message appears
again on the LCD, contact your local
distributor to call for service.
Occurrence of a timeout error on a
USB device.
The X motor has been overload.
The Y motor has been overload.
Overcurrent error on the X motor has
been detected.
Overcurrent error on the Y motor has
been detected.
Blowout of the fuse of the main PCB
occurs.
• Contact your local distributor to call for
service.
Abnormal head temperature
• Turn off the power to the device an
turn it on after a while.
• If the same error message appears
again on the LCD, contact your local
distributor to call for service.
An error has been detected during Z
axis control.
Wait for Z axis stop has failed.
• Turn off the power to the device an
turn it on after a while.
• If the same error message appears
again on the LCD, contact your local
distributor to call for service.
• Expand the range of the correction
parameter threshold.
After performing the feed correction, it
did not fall within the range of the
threshold.
Both the left axis and the right axis are
not terminated within the range of in
position even if a certain period of time
has been passed.
• Turn off the power to the device an
turn it on after a while.
• If the same error message appears
again on the LCD, contact your local
distributor to call for service.
The right axis is not terminated within
the range of in position even if a
certain period of time has been
passed.
The left axis is not terminated within
the range of in position even if a
certain period of time has been
passed.
Y origin could not be detected.
• Turn off the power to the device an
turn it on after a while.
• If the same error message appears
again on the LCD, contact your local
distributor to call for service.
Head temperature is abnormal
condition.
Abnormal linear scale
To Next Page
Loading...
