MIMAKI JFX200-2513EX - Page 100

Chapter 3 Convenient Usage
3-32
4
Press to select [EXE I/F].
MACHINE SETUP
[ENT]
EXE I/F
5
Press the [ENTER] key.
EXE I/F
: OFF
6
Press to select "ON" or "OFF".
• ON: Use External Stop I/F.
• OFF: Do not use External Stop I/F.
EXE I/F
: ON
7
Press the [ENTER] key.
MACHINE SETUP
[ENT]
EXE I/F
8
Press the [END] key several times to end the operation.
• If you change the External Stop I/F in REMOTE mode, the following warning is displayed, and the
machine will switch to LOCAL mode.
ERROR 513
SENSE OBSTRUCTION
• If an obstacle is detected, a warning is displayed, and the machine does not switch to REMOTE
mode.
• The printing operation using the built-in pattern (Nozzle check, drop position correction) will continue
regardless of the state of External Stop I/F.
• In LOCAL mode, External Stop I/F detection is always "OFF".
• If you do not know whether the sensor you are using is compatible with the I/F, consult our support
team.