MIMAKI JFX200-2513EX - Head Cleaning

Chapter 2 Basic Usage
2-15
Head Cleaning
Check the printed test pattern results and perform cleaning depending on the symptoms.
Head cleaning can be done in three ways. Use them based on the pattern print results.
1
Press the [CLEANING] key in LOCAL mode.
CLEANING
SOFT
[ENT]
2
Press to select a cleaning type.
• SOFT:
When lines are bent or missing
• NORMAL:
When one or more lines are missing or are composed of mixed colors
• HARD:
When poor image quality cannot be corrected even if cleaning is performed in NORMAL or SOFT
mode
CLEANING
NORMAL
[ENT]
3
Press the [ENTER] key.
SELECT HEAD
: 1 2 3
4
Press to select the head for cleaning.
• Available settings:
1 2 3 (all the heads)
1 _ _ (head 1)
_ 2 _(head 2)
_ _ 3 (head 3)
SELECT HEAD
: 1 _ _
Head1
Head3
Rear side
of this
machine
Head2
5
Press the [ENTER] key.
**CLEANING**
PLEASE WAIT
6
Run the test print again and check the print results.
• Repeat the cleaning and test printing until the print results are normal.
2