MIMAKI JFX200-2513EX - Automatic Checking of the Media Thickness

Chapter 3 Convenient Usage
3-5
3
Press the [ENTER] key.
HEAD GAP = 1.2
ORIGIN SETUP
MEDIA THICKNESS = *.* mm
ORIGIN SETUP
Automatic Checking of the Media Thickness
Media thickness is automatically checked by the gap pin located at the center of the carriage.
1
Set the media.
• Be sure to set the media within the print range. If automatic thickness check is conducted without
inserting the media, the print heads may get damaged.
2
Press the [FUNCTION] key in LOCAL.
FUNCTION
[ENT]
VIEW
3
Press to select the [HEAD HEIGHT].
FUNCTION
[ENT]
HEAD HEIGHT
4
Press the [ENTER] key.
HEAD HEIGHT
[ENT]
MEDIA THICKNESS
5
Press to select the [THICKNESS CHECK].
HEAD HEIGHT
[ENT]
THICKNESS CHECK
6
Press the [ENTER] key.
• To prepare the machine for the thickness check, the Y-bar is raised to the highest point.
• The carriage moves inside the print area.
** MOVING NOW **
PLEASE WAIT
THICKNESS CHECK
CHECK START
7
Press the [ENTER] key.
• The media thickness is checked automatically.
• The checked thickness is displayed.
• The carriage returns to the retracted position, and the display returns to Step 5.
THICKNESS CHECK
** CHECKING **
THICKNESS CHECK
3.0 mm
** MOVING NOW **
PLEASE WAIT
8
Press the [END] key several times to end the operation.
• Tolerance of the automatic thickness check is ±0.1 mm.
3