MIMAKI JFX200-2513EX - NOZZLE RECOVERY Functionality

Chapter 4 Maintenance
4-25
NOZZLE RECOVERY Function
If nozzle clogging cannot be improved at the specified points, other good nozzles can be used as
alternatives (nozzle recovery) for printing.
The structure of the head is as shown in the following figure.
With the nozzle recovery function, you can set nozzle recovery by specifying the nozzle lines for H1-3 (heads
1-3) respectively.
Head1
Head3
Rear side
of this
machine
Head2
• The machine is equipped with four nozzle lines (A, B, C, and D) for each head.
A
B
C D
1
Select [NOZZLE RECOVERY] of the MAINTENANCE menu.
(1) Press the [FUNCTION] key in LOCAL.
(2) Press to select [MAINTENANCE], and press the [ENTER] key.
(3) Press to select [NOZZLE RECOVERY].
(4) Press the [ENTER] key.
2
Press to select [PRINT], and press the [ENTER] key.
NOZZLE RECOVERY
: PRINT
NOZZLE RECOVERY
[ENT]
PRINT START
4