Chapter 4 Maintenance
4-24
8
Press the [ENTER] key.
9
Release the colored ink or the air mixed in the ink.
• When you press the [ENTER] key, the machine goes into a state of atmospheric release and the
ink comes out vigorously.
• Allow it to discharge until the colored ink or the air in the ink is completely gone. Thereafter, ink
without any mixed colors will be discharged.
• The buzzer sound goes off at regular intervals while the ink is being discharged.
AIR PG. [DISCHARGE]
[ENT]
COMPLETED
10
Perform Step 9 for all ports from which air is purged.
• The carriage may moves quickly at times. Keep your hands, head, or your body away from the
carriage.
11
Press the [ENTER] key.
12
Press the [ENTER] key.
13
Remove the jig and re-attach the cap.
• Re-attach the cap immediately after removing the jig.
14
Once the cap is re-attached, press the [ENTER] key.
• Negative pressure control restarts and wiping begins.
REMOVE TOOL
[ENT]
COMPLETED
PLEASE WAIT
15
Press to select "COMPLETED" or "RETRY".
• If you select "COMPLETED" cleaning is performed. Once the cleaning is complete, proceed to
Step 18.
• If you select "RETRY" the screen returns to Step 2. Select another port and perform the air purge
operation.
16
Press the [END] key several times to end the operation.
17
Close the maintenance cover.
• After the work is complete, quickly attach the removed cover. If you leave it removed for a long time,
ultra-violet rays may affect the ink.
To Next Page
Loading...
