Chapter 4 Maintenance
4-23
6-Color + W
• Turn the cap 30° counterclockwise and then remove it.
• Ink is stuck on the removed cap. Temporarily place it on a paper towel, etc. to avoid contamination
of the surrounding area.
• Perform air purge for each head. Do not remove the caps of head 2, head 3 when performing air
purge for head 1.
• The internal mechanism does not let the ink spill out even if the cap is removed.
7
Connect the jig to the port.
• Similar to the cap, connect the jig by pushing the tip into the port and rotating it clockwise by 30°.
Jig
Insert the jig in the wiper part to fix it in place
• There is a magnet attached to the bottle of the air purge jig. When attaching the bottle to the
machine, try to place it at the lowest position possible.
4
To Next Page
Loading...
