MIMAKI JFX200-2513EX - Function List and Setting Reference

Chapter 3 Convenient Usage
3-8
List of Functions
This section outlines the various functions and describes their settings.
• Default "HOST" function
The value specified in the RIP software runs this function. When a value other than "HOST" is specified,
the specified value is used instead of waiting for instructions from the RIP software.
Note that some functions may not be available depending on the RIP software used. In such cases, the
value "When there are no instructions from RIP".
• For how to specify values in the RIP software, see the RIP software guide.
Function name Available
settings
*1
If there is no
instruction
from RIP
*2
Outline
DROP.POScorrect
"Correcting the Drop Position" (P. 3-9)
-40.0 to 0.0 to
40.0
——— Adjusts the dot position in
reversible printing.
LOGICAL SEEK
"Setting LOGICAL SEEK" (P. 3-11)
HOST/ON/
OFF
ON Sets the scan movable area
during printing.
INK LAYERS
"Other Settings" (P. 3-24)
HOST/1 to 9 1 Sets the number of layers in
which ink is to be applied.
UV LEVEL
"Setting UV LEVEL" (P. 3-13)
HOST/
MANUAL
MANUAL Specifies the UV irradiation
pattern during printing.
REFRESH
"Other Settings" (P. 3-24)
HOST/Lv.0
(long refresh
interval) to 3
(short refresh
interval)
Lv.3 Refreshes the ink heads during
printing.
MAPS
"MAPS Function" (P. 3-15)
OFF/MAPS2 ——— Performs settings to reduce
stripes between the passes.
MAPS2 AUTO ———
MANUAL PATTERN (1
to 4)/
SMOOTHING
LV. (AUTO/5
to 100%)
———
WORK CHANGE
"WORK CHANGE Settings" (P. 3-19)
HOST/ON/
OFF
——— Sets the operations to complete
the printing.
IONIZER
"Ionizer Settings" (P. 3-20)
ON/OFF ——— Sets an optional IONIZER.
AUTO CLEANING
"AUTO
CLEANING
Settings" (P. 3-21)
OFF/PAGE ——— Sets up automatic head cleaning
to be performed before or during
printing.
PAGE INTERVAL 1 to 3 to 1000 ———
TYPE NORMAL/
SOFT/HARD
———
INTERVAL WIPING
"Setting Nozzle Surface Cleaning
Frequency" (P. 3-23)
ON/OFF ——— Sets up the wiping operation
performed during printing.
*1. It is set to the underlined value at the time of purchase.
*2. This is the value used for printing when the value set in the machine is to be prioritized or if no value is set in the RIP software (host), even if the type
registration of this machine is set to "HOST".