Chapter 5 Troubleshooting
5-4
1
Press the [ENTER] key in LOCAL mode.
LUS-150 CMWWYKClCl
34567899
REMAIN
2
Press the [ENTER] key.
• Details of the ink bottle error are displayed.
• When multiple ink bottle defects occur, they will be displayed in order if you press the [ENTER] key
or .
Ink leakage
If the ink starts leaking, switch off the main power, disconnect the power plug, and contact your local
distributor, or our sales office or call center.
If the message "SHAKE WHITE INK BOTLES" is displayed
White ink tends to settle, and hence you must shake the ink bottle periodically.
When using white ink, a message will be displayed periodically prompting you to shake the white ink bottle.
Follow the procedure below to shake the white ink bottle.
SHAKE WHITE INK
BOTTLES
[ENT]
1
Take out the white ink bottle and gently shake it side to side 20 times or more.
• To prevent the ink from leaking when the bottle is shaken, wear hand gloves and close the lid of
the ink bottle with a paper towel. Then shake the bottle from side to side at least 20 times to
ensure a slow ink flow.
• Make sure that the lid is closed tightly before shaking the bottle.
• The ink may leak outside if you shake the bottle too hard. Shake carefully.
• If only a small amount of ink is remaining, it may not be possible to stir it properly. To stir it properly,
tilt the ink bottle until it becomes vertical.
Repeat
Hold down tightly with a paper towel and shake well
To Next Page
Loading...
