MIMAKI JFX200-2513EX - Replacing the Waste Ink Tank before the Waste Ink Tank Confirmation Message Is Displayed (2)

Chapter 4 Maintenance
4-38
8
Press to set the "Level" to "0%".
Check waste ink
Level : 0% (0.0L)
9
Press the [ENTER] key.
Replacing the waste ink tank before the waste ink tank confirmation
message is displayed (2)
Set the waste ink information to 0% in the MAINTENANCE menu.
1
Empty the waste ink tank.
• "Disposing of Waste Ink" (P. 4-35)
2
Press the [FUNCTION] key in LOCAL.
FUNCTION
[ENT]
SETUP
3
Press to select [MAINTENANCE].
FUNCTION
[ENT]
MAINTENANCE
4
Press the [ENTER] key.
MAINTENANCE
STATION MAINT.
5
Press to select [InkTankExchange].
MAINTENANCE
[ENT]
InkTankExchange
6
Press the [ENTER] key.
• When you press the [ENTER] key, the waste ink information becomes 0%.
InkTankExchange
EXCHANGE
Running this menu will give the same result as when 0% is set in [USAGE] as shown on the previous page.