MIMAKI JFX200-2513EX - External Stop I;F

Chapter 3 Convenient Usage
3-31
9
Press the [END] key several times to end the operation.
• To reflect the new network settings, turn the power off and back on.
External Stop I/F
In this machine, you can connect External Stop I/F to the I/F in the figure below (SMP-02V-BC).
External Stop I/F
(SMP-02V-BC)
SMP-02V-BCSMR-02V-B
Printer side Area sensor or the like
Control circuit board
External Stop I/F
b-contact
• Arrange for a connector (SMR-02V-B).
External Stop I/F specifications: b-contact (Normal Close)
• Never connect the power source of External Stop I/F anywhere except the sensor line.
External Stop I/F Settings
You can set the operation for when a stop sensor is connected to the External Stop I/F.
1
Press the [FUNCTION] key in LOCAL.
FUNCTION
[ENT]
VIEW
2
Press to select [MACHINE SETUP].
FUNCTION
[ENT]
MACHINE SETUP
3
Press the [ENTER] key.
MACHINE SETUP
[ENT]
AUTO Power-off
3