MIMAKI JFX200-2513EX - Page 98

Chapter 3 Convenient Usage
3-30
2
Press to select [NETWORK] and press the [ENTER] key.
MACHINE SETUP
[ENT]
NETWORK
3
Press the [ENTER] key.
• [Check IP ADDR.] is selected.
• This displays the IP address the machine is currently using.
• After checking, press the [ENTER] key.
NETWORK
Check IP ADDR.
• After connecting to the network, it takes time for the IP address to be confirmed. If the IP address is
not set, [0.0.0.0] is displayed.
4
Press , and press the [ENTER] key.
• [Check MAC ADDR.] is selected.
• This displays the MAC address the machine is currently using.
• After checking, press the [ENTER] key.
NETWORK
Check MAC ADDR.
5
Press , and press the [ENTER] key.
• [DHCP] is selected.
NETWORK
DHCP
6
Press to select "ON" or "OFF", and press the [ENTER] key.
DHCP
=
ON
• Available settings: ON/OFF
• If set to "ON", an IP address received from the DHCP server is used.
7
Press , and press the [ENTER] key.
• [AutoIP] is selected.
NETWORK
AutoIP
8
Press to select a setting, and press the [ENTER] key.
• Available settings: ON/OFF
• If set to "ON", the IP address to be used is set according to the AutoIP protocol. However, if DHCP
is "ON, DHCP takes priority.
AutoIP
=
ON