Chapter 1 Before Use
1-26
If the light-blocking cover comes off
When the light-blocking cover comes off, light penetrating into the tank may cause the ink to harden.
Perform the following steps to reattach the light-blocking cover:
1
Insert the light-blocking cover (one nub) into the cover insertion hole on the tank.
2
While pressing the cover into the cap insertion hole as explained in Step 1, insert the other
nub into the other insertion hole.
Ink Bottle Lamps
You can check the status of the ink bottles set over the tank by looking at the lamp on the top of the ink
bottle.
To Next Page
Loading...
