Chapter 1 Before Use
1-19
Ink Bottles
Types of Usable Inks
Following inks can be used with this machine.
4-color + white + clear model
(LUS150, LH100, LUS120)
Uses one bottle each of cyan, magenta, yellow, and black and two bottles
each of clear and white
4-color + white + clear + primer model
(LUS150, LH100, LUS120)
Uses one bottle each of cyan, magenta, yellow, black, clear, and primer
and two bottles of white
6-color + white model + clear
(LUS150, LH100)
Uses one bottle each of cyan, magenta, yellow, black, light cyan, and
light magenta and two bottles of white
ClearInk to be used varies depending on the ink type used.
Ink type Ink type of ClearInk
LUS150 LH100
LH100 LH100
LUS120 LUS120
Please note that a combination other than those mentioned above cannot be used.
Setting Ink Bottles
1
Take out the ink bottle and gently shake it side to side 20 times or more.
• To prevent the ink from leaking when the bottle is shaken, wear hand gloves and close the lid of the
ink bottle with a paper towel. Then shake the bottle from side to side at least 20 times to ensure a
slow ink flow.
• Make sure that the lid is closed tightly before shaking the bottle.
• Be careful while shaking the bottle, because the ink may leak to outside if you shake the bottle too
hard.
• If only a small amount of ink is remaining, it may not be possible to stir it properly. Hence, to stir the
ink properly, tilt the ink bottle until it becomes vertical.
Repeat
Hold down tightly with a paper towel and shake well
1
To Next Page
Loading...
