Chapter 1 Before Use
1-20
2
Remove the cap of the ink bottle.
• When using LUS-150, remove the cap and open the seal attached to the bottle with a cutter. When
opening the seal, cut a circle as shown in the following figure. Make sure that the seal does not fall
into the bottle.
Cut out a circle with the cutter, as
shown in the figure on the left.
3
Attach the specialized cap to the ink bottle.
4
Set the specialized cap on the ink bottle.
• The cap to be used differs depending on the type of ink to be used.
View of the upside down cap
The edge of cap B is thicker.
Cap A Cap B
Specialized cap
Type of ink Cap Used
LUS-150 ink Cap A
LH100 ink Cap B
Primer ink Cap B
LUS-120 ink Cap B
To Next Page
Loading...
