MIMAKI JFX200-2513EX - Using FUNCTION Menu to Change the Print Origin

Chapter 3 Convenient Usage
3-3
Using FUNCTION menu to Change the Print Origin
When setting an exact origin, set the X and Y coordinates of the origin from the FUNCTION menu.
When the origin is set by using this option, the set value becomes the point of origin (0.0).
1
Press the [FUNCTION] key in LOCAL.
FUNCTION
[ENT]
VIEW
2
Press and select [ORIGIN], and press the [ENTER] key twice.
• The screen changes to the X-axis offset value setup screen.
X OFFS:
ORIGIN
1200 mm
1300 mm
3
Press to enter the numerical value.
• Set X-axis origin.
X OFFS:
ORIGIN 1300 mm
1290 mm
4
Press the [ENTER] key.
SELECT: X OFFSET
ORIGIN
5
Press to select the [Y offset], and press the [ENTER] key.
SELECT: Y OFFSET
ORIGIN
6
Press to enter the numerical value.
• Set Y-axis origin.
Y OFFSET:
ORIGIN 2500 mm
2090 mm
7
Press the [ENTER] key.
SELECT: Y OFFSET
ORIGIN
8
Press the [END] key several times to end the operation.
• The set origin is not cleared even when the power is turned off.
3