MIMAKI JFX200-2513EX - Setting the Print Origin Point

Chapter 3 Convenient Usage
3-2
Changing the Point of Origin
The factory setting of point of Origin can be changed.
It can be changed in one of the two ways.
Media
Light pointer mark
New point of origin
Old point of origin
Setting the point of origin by using
JOG keys
Table
Changing with the JOG keys Changing from "ORIGIN" in the
[FUNCTION] menu
Using JOG Keys to Change the Print Origin
1
Press in LOCAL.
• The screen changes to [ORIGIN SETUP].
• A red "● ( light pointer mark)" appears on the table or media.
ORIGIN SETUP
0.0
2
Press to move the light pointer mark.
• Move the light pointer mark to the position set as the new origin.
ORIGIN SETUP
600.0
500.0
Point of origin
(front-back)
Point of origin
(left-right)
3
Once the print origin has been determined, press the [ENTER] key.
• The origin has changed.
** ORIGIN **
• The origin set by using the JOG keys is cleared when the power is turned off.