MIMAKI JFX200-2513EX - Aborting a Printing Operation; Deleting the Received Data (Data Clear); Moving the Y-Bar; Deleting the Received Data (Data Clear).2-18

Chapter 2 Basic Usage
2-18
4
Remove the media after the completion of printing.
(1) Move the Y-bar outside the table.
"Moving the Y-bar" (P. 2-18)
(2) Press the [VACUUM] key to turn off suction.
(3) Take out the media.
• The media may get lifted and the print may get aborted due to the heat generated by the LED UV during
printing.
Reset the new media and start printing.
Aborting a Printing Operation
To stop printing halfway through, perform the following operations:
1
Press the [REMOTE] key while printing.
• The printing operation stops.
• Stop any data transfer from the PC by interrupting the process from the PC.
• If you press the [REMOTE] key again, the printing operation restarts from the point at which the
printing operation was aborted.
<LOCAL>
DATA REMAIN
Deleting the Received Data (Data Clear)
If you want to stop printing, delete the already received data.
1
Press the [DATA CLEAR] key in LOCAL.
DATA CLEAR
[ENT]
2
Press the [ENTER] key.
• Deletes the received data and returns to LOCAL mode.
**DATA CLEAR**
Moving the Y-bar
The Y-bar can be moved to check the print results or to perform similar operations.
Set the Y-bar retracting position (VIEW position) in advance.
Setting the VIEW Position
1
Press the [FUNCTION] key in LOCAL.
FUNCTION
VIEW
[ENT]