MIMAKI JFX200-2513EX - Page 163

Chapter 5 Troubleshooting
5-9
Message Cause Solution
<LOCAL>
INK NEAR END [ENT]
There is a small amount of
ink in the supply unit.
• Press the [ENTER] key to check
the corresponding ink bottle.
Ink is nearly used up.
<LOCAL>
SUPPLY: CMYKYKMCClClWW
Failure to refill ink in the
sub tank.
• Perform sub tank maintenance.
If an error related to the sub tank
occurs
Also check the remaining amount
of ink in the ink bottle.
If the message is displayed even
after executing this step, contact
your local distributor, or our sales
office or call center.
<LOCAL>
SUB TANK: CMYKYKMCClClWW
Liquid level sensor
abnormality of the sub tank
has been detected.
• Turn off the power on the machine
and turn it on after a while.
If displaying again, contact your
local distributor, our sales office, or
service center.
<LOCAL>
Overflow: CMYKYKMCClClWW
Ink overflow from the sub
tank has been detected.
• Perform sub tank maintenance.
If an error related to the sub tank
occurs
If displaying again, contact your
local distributor, our sales office, or
service center.
<LOCAL>
LevelH: CMYKYKMCClClWW
Though certain amount was
consumed, there is no
change in the sub tank
sensor error indicating high
level.
<LOCAL>
LevelL: CMYKYKMCClClWW
Though certain amount was
consumed, there is no
change in the sub tank
sensor error indicating low
level.
<LOCAL>
MACHINE TEMP./H ***°C
Machine temperature is
high.
• Adjust the ambient temperature of
the place where the machine is
used.
<LOCAL>
MACHINE TEMP./L ***°C
Machine temperature is
low.
<LOCAL>
Replace SupplyPUMP
The supply pump in the ink
path must be replaced
soon.
• The supply pump needs to be
replaced.
Contact your local distributor, our
sales office, or service center.
<LOCAL>
Replace SuctionPUMP
The suction pump in the ink
path must be replaced
soon.
• The suction pump needs to be
replaced.
Contact your local distributor, our
sales office, or service center.
<LOCAL>
Replace Ymotor Brush
Time to replace the brush
of Y motor.
• The brush of Y motor needs to be
replaced.
Contact your local distributor, our
sales office, or service center.
Ink error
Ink error is also displayed in the local guidance.
"Displaying other information" (P. 3-40)
Message Cause Solution
NON INK IC
: ---- YYKK
Ink IC chip of the ink bottle
cannot be read properly.
• Reinsert the ink bottle for which the
warning occurred.
If displaying again, contact your
local distributor, our sales office, or
service center.
WRONG INK IC
: ---- YYKK
INK TYPE
: ---- YYKK
The ink of the ink bottle is
of a different type than the
ink currently supplied.
• Check the ink type of the ink bottle
for which the warning occurred.
5