Chapter 2 Basic Usage
2-7
Media Guide Holes
The table edges (both top and bottom) are provided with guide holes for inserting the layout pins provided
with the printer. Use these guide holes to keep the media straight.
• A commercially available M3 screw can be used instead of the positioning pin provided with the printer. In
that case, screws can be used to secure the media to both the left and front sides of the table.
• When using the provided layout pin, the media thinner than 5 mm cannot be used.
• When printing on a media having a thickness of 5 mm or less, make sure that the layout pin has been
removed from the top of the table.
Layout pin mounting hole
Layout pin
Print area
M3 screw mounting hole
Origin (0,0)
2
To Next Page
Loading...
