Chapter 3 Convenient Usage
3-10
7
Press to correct the drop position from pattern 1 onwards.
• Corrected value: -40.0 to 40.0
• The position at which the outward feed line and the return feed line become one straight line is the
correction value.
• If the compensation value is not between -40.0 and 40.0, adjust the height of the printing heads
and then re-perform the operations from Step 2 onwards.
Output direction
The outward feed line and the return feed line of
the fourth pattern from 0 position in the positive
direction form a straight line.
Hence, in this case the drop position correction
value is 4.0.
8
Press the [ENTER] key.
• Displays the next pattern input.
• Repeat Step 7.
9
Press the [END] key several times to end the operation.
Drop position correction without using the [ADJUST] key
The drop position can be corrected by using the [FUNCTION] key in LOCAL even without pressing the
[ADJUST] key.
1
Press the [FUNCTION] key in LOCAL.
2
Press , select [SETUP] and press the [ENTER] key.
3
Press to select [DROP.POScorrect], and press the [ENTER] key.
• The operation is same as that when [ADJUST] key is pressed in LOCAL.
To Next Page
Loading...
