When Nozzle Clogging Cannot Be Solved
4-15
1
1
1
4
Routine Maintenance
5
Attach the clean stick to the extension bar.
(1) Insert the clean stick between the holding plates
until it hits.
(2) Fix it with the screw.
6
Wipe the nozzle surface.
• After ink purge, ink on the nozzle surface is absorbed into the nozzle after a certain time has passed.
Wipe the nozzle surface right after ink purge, not taking any time.
• For wipe, use the clean stick (SPC-0527) or the wiper kit for purge (SPA-0202). Use a new clean stick
having neither dirt nor dust on it.
• The wiper kit for purge is sold separately.
• Fully clean the wipe part of the wiper kit for purge before using.
• Gently put the flat surface of the sponge part of the clean stick against the nozzle surface rear side, and
move the clean stick from the rear to the front taking 2 or 3 seconds to wipe off ink adhering to the
nozzle surface.
7
Press the key.
• Do not rub the nozzle surface strongly.
• Do not use any dirty clean stick.
• If the clean stick absorbed much ink, the wiping ability
may be degraded. In such a case, use new one. If you
use such a clean stick continuously after squeezing ink
of the sponge part, dust adhering to the sponge part
etc. may scratch the nozzle surface, or dust may be
pushed against the nozzle and it may cause discharge
defect.
To Next Page
Loading...
