MIMAKI SWJ-320 S2 - Changing the Printing Origin

2-19
1
2
Basic Operations
4
5
6
Setting a Media
Changing the printing origin
The position of the printing origin can be changed.
Moving the carriage to the changing position and deciding the position.
1
In Local, Press .
• It enters into the origin setting mode.
2
Set an arrow mark of the carriage to the changing position by pressing
.
• Select the carriage and media, moving the point with
.
3
After determining the origin, press the key.
• The printing origin is changed.
• When detecting roll media, you cannot
move the media with the key.
OR I G I N SE TUP
0.0 ----
OR I G I N SE TUP
0.0 0.0
Origin
(Length)
Origin
(Width)
OR I G I N SE TUP
** ORIGIN **