3-2
List of Functions
This section describes the overview of each function to be set and set values that can be registered in user
types.
• About default “HOST” function
You can operate this by the setting value specified in RIP software.
When you set to other than “HOST”, it operates by that setting value, not by the instruction from RIP
software.
Depending on RIP software, there are some functions that cannot be instructed by software. In such a
case, it operates by the setting value of “When no instruction from RIP exists”.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value Default
When no instruction
from RIP exists
*1
*1. This is the setting value to be used for printing when setting value is not specified at the RIP software (host) side, or, you give priority
to the setting value at the machine side, even if you set “Host” to the type registration of this machine.
Outline
FEED COMP. ( P.2-26) -9999 ~ 0 ~ 9999 0
Used to print a pattern for
correcting a media-feeding rate
and correct it.
DROP. POS CORRECT -40.0 ~ 0 ~ 40.0 0
Used to adjust the dot position in
go and return printing.
LOGICAL SEEK
(P.3-3)
HOST / ON / OFF HOST
OFF
Sets the scan movable area
during printing.
INK LAYERS ( P.3-11) HOST /1 ~ 9 HOST
1
Sets the number of layers in
which ink is to be applied.
DRYING
TIME
(P.3-3)
SCAN HOST /0.0 ~ 99 sec HOST
0.2 sec
Sets the time to wait for ink
drying.
PRINT END HOST /0 ~ 999 sec HOST
0 sec
REFRESH HOST / Lv.0 ~ Lv.3 Lv.3
Lv.3
Sets the refreshing operation to
stabilize the nozzle condition in
printing.
PRINT
SPEED
(P.3-11)
SCAN SPEED
70 ~ 100% 100%
Changes the print head moving
speed and the media feeding
speed during printing.
*2
*2. When you set “FEED SPEED” to “100%” or more, required time for completion of printing will be shortened. However, enough drying
time cannot be ensured and it may affect the image quality. In addition, when you set “FEED SPEED” to “100%” or more, the media
feeding accuracy may be degraded.
FEED SPEED
HOST / 10 ~ 300% HOST
100%
MAPS
(P.3-5)
OFF / ON OFF
Perform setting to reduce stripes
between passes.
PRINT SPEED
ADJUST
-50 ~ +50% 0%
AUTO
CLEANING
(P.3-7)
PAGE OFF/ 1~1000 OFF
Sets the automatic cleaning
operation of the head at the start
of printing.
LENGTH OFF/ 0.1~100m OFF
INTERVAL WIPING( P.3-8)
AUTO, 10~2540s,
OFF
AUTO
Sets the wiping operation during
printing.
To Next Page
Loading...
