MIMAKI SWJ-320 S2 - Washing Head Nozzles

4-16
Washing of Head nozzle
Perform cleaning of the nozzles in the heads to prevent them being clogged with coagulated ink.
1
Press the key in LOCAL.
2
Press to select [NOZZLE WASH].
3
Press the key.
• The carriage moves to the maintenance position.
4
Clean the wiper and the bracket.
(1) Open the right maintenance cover then pull out it by holding projections at both ends of the
wiper.
(2) Clean the wiper and bracket with a clean stick dipped in cleaning solution for maintenance.
(SPC-0563) Wipe off so that cleaning solution for maintenance will not remain.
(3) Insert it in the original position by holding the projections at both ends of the wiper.
5
Press the key.
• The carriage moves onto the platen.
Check the items on the
right beforehand.
Is [NEAR END] or [INK END] displayed?
• The cleaning solution or ink is absorbed when the nozzles are washed.
At this time, if the state of "no ink" or "almost no ink" is detected, the nozzle
washing operation cannot start.
• Replace the ink bottle with another from which the state of "almost no ink" or "no
ink" is not detected.
• Until wiper cleaning is competed, [COMPLETED (NEXT): ENT] is displayed on the screen. After
the work up to the step 4 is completed, press the key. If you press the key
before cleaning is completed, the machine moves to the next washing procedure.
• Until wiper cleaning is competed, [COMPLETED (NEXT): ENT] is displayed on the screen. After
the work up to the step 6 is completed, press the key. If you press the key
before cleaning is completed, the machine moves to the next washing procedure.
STAT I ON
CARR I AGE OUT [ ENT ]
STAT I ON
NOZ Z L E WASH [ ENT ]
WI PER CLEAN I NG
COMP L ETED ( NEXT ) [ ENT ]
Projection
CAP CLEAN I NG
COMP L ETED ( NEXT ) [ ENT ]