MIMAKI SWJ-320 S2 - Ink Head Cleaning; Cleaning Ink Head Area

4-12
Cleaning the Ink Head and the Area around It
Because the ink head employs a very precise mechanism, due care needs to be taken when it is cleaned.
Using a clean stick, etc., rub off gelatinous ink or dust that may stick to the lower part of the slider and the area
around the ink head.In doing so, never rub the nozzles of the head.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [HEAD MAINT.].
4
Press the key.
• Carriage will move to the left end of this device.
5
Open the left maintenance cover.
6
Attach the clean stick to the extension bar.
(1) Insert the clean stick between the holding plates
until it hits.
(2) Fix it with the screw.
Tools required for cleaning
• Clean stick (SPC-0527) • Gloves • Goggles
• Be sure to wear the attached goggles and gloves when cleaning the area around the ink
head.Otherwise, you may get ink in your eyes.
• The ink contains organic solvent.If you get the ink on your skin or in your eyes, wash it away with
plenty of water immediately.
STAT I ON
CARR I AGE OUT [ ENT ]
MOV E ME N T P L A C E
:STATION MAINT.
MOV E ME N T P L A C E
:HEAD MAINT.
Carriage
Maintenance cover
Holding plates
Fixing screw
Extension bar
Clean stick