MIMAKI SWJ-320 S2 - Nozzle Recovery Functionality

4-18
Alternative nozzles for printing, when nozzles missing can not be improved
NOZZLE RECOVERY: When nozzles missing can not be improved at specific points, other good nozzles can
be used as alternatives for printing.
Valid/ invalid of nozzle recovery function in each print mode
X: Print mode where nozzle recovery function is invalid
O: Print mode where nozzle recovery function is valid
• Depending on the print mode, the nozzle recovery function becomes invalid. When the nozzle
recovery function becomes invalid, you cannot print with an alternative nozzle.
Confirm the list of “Valid/ invalid of nozzle recovery function in each print mode”, and print with the
print mode where the nozzle recovery function is valid.
• In addition, even in the print mode where the nozzle recovery function is valid, recovery may not be
reflected depending on the registered nozzle. Check the print condition where the recovery cannot be
performed in the check function, and then select the print mode. ( P.4-23)
Print mode
Nozzle
recovery
Print mode
Nozzle
recovery
360x600dpi
2pass Bi / Uni X
1080x600dpi
2pass Bi / Uni X
4pass Bi / Uni O 4pass Bi / Uni O
8pass Bi / Uni O 8pass Bi / Uni O
540x600dpi
2pass Bi / Uni X
1080x600dpi
High speed
4pass Bi / Uni X
4pass Bi / Uni O 8pass Bi / Uni O
8pass Bi / Uni O
1080x900dpi
3pass Bi / Uni X
720x600dpi
2pass Bi / Uni X 6pass Bi / Uni O
4pass Bi / Uni O 12pass Bi / Uni O
8pass Bi / Uni O
1080x900dpi
High speed
6pass Bi / Uni X
720x600dpi
High speed
4pass Bi / Uni X 12pass Bi / Uni O
8pass Bi / Uni O
1080x1200dpi
4pass Bi / Uni X
720x900dpi
3pass Bi / Uni X 8pass Bi / Uni O
6pass Bi / Uni O 16pass Bi / Uni O
12pass Bi / Uni O
1080x1200dpi
High speed
8pass Bi / Uni X
720x900dpi
High speed
6pass Bi / Uni X 16pass Bi / Uni O
12pass Bi / Uni O