MIMAKI SWJ-320 S2 - Head Height Adjustment; Head Height Adjustment Steps

2-14
Adjusting the Head Height
1
Set the media and push down the clamp lever.
2
Set the adsorption fan to ON.
3
Press the key.
4
Press to select [Head Height].
5
Press the key twice.
• The carriage will move.
6
Press the key.
(1) Open the front cover and the maintenance cover R.
(2) Move the carriage by hand until the head height
adjusting rod comes on the media.
• If the carriage hits the spacer or the Media press, go to
the step 9 and raise the head.
• Unless the head is properly set at the height against the thickness of the media you use, deterioration
of the printing quality or the breakage of the head could be caused. Perform the head height
adjustment each time when you change the media.
• When the height of the head is set at 2.0mm (minimum value) from the surface of the platen, pay
attention to the following points:
(1) Use the media with surface without wrinkles and convex-concave shapes. The media and
the head may graze with each other, or the media may be caught and pressed by the head
causing a jam of being clogged at some point.
• After adjusting the head height, make sure to perform the correction of the dot position. （ P.2-32）
• If the printing area has been set, the printing area is reset.
Set the printing area again.
MED I A SET
MED I A RESET [ ENT ]
MED I A SET
HEAD HE I GHT [ ENT]