Waste ink tank
Waste ink gathers in this tank.
Front cover
Open the cover in setting of medias, taking of measures against jamming of medias
or in maintenance inside the station.
Even when the power switch is off, keep this cover and the other covers closed.
Operation panel
This panel has the operation keys required for
operating the machine and the LCDs for displaying
Clamp lever
Moves the pinch rollers up
and down to hold or release
Blowing fan
Stand
Supports the main body of the machine.
Caster for moving and adjuster-foot for
fixing are equipped.
Left maintenance cover
Open the cover in maintenance.
Even when the power switch is off, keep all covers closed.
Platen
The printed media is sent out, sliding on the platen. Three heaters are installed inside the platen.
Print heater/ Post-heater
Fixes and dries the ink on the currently produced print. (Located inside the platen)
Inkbottle table
Use it to place each color inkbottle.
Take-up device
Take up the output drawn with a
roll medium automatically.
Drying fan
Right maintenance cover
Drying fan switch
Controls ON/OFF of Drying fan
unit.
Heater panel
Sets the heater temperature of platen
and ON/OFF of adsorption fan.
Stop switch (L/R)
Stops the operation of carriage immediately.
To Next Page
Loading...
