Maintenance
4-3
1
1
1
4
Routine Maintenance
Cleaning the Exterior Surfaces
When the exterior surfaces of the machine are stained,
dampen a soft cloth with water or a neutral detergent
diluted with water, squeeze it, and wipe the surfaces
with the cloth.
Cleaning the Platen
The platen easily gets dirty with lint, paper dust, etc.
generated when a media is cut.
Wipe off conspicuous stains with a soft-hair brush, a dry
cloth, a paper towel, etc.
Cleaning of after heater cover and pre heater cover
The after heater cover and the pre heater cover are easy to be dirty because of the powder of the medium etc.
If it shows dirt, wipe it with a soft cloth soaked in water or waterish mild detergent and wrung.
• Before cleaning the platen, make sure that the platen has cooled adequately.
• Because dust and dirt are easily accumulated in the slots for holding a media and cutting paper (cutter
slot), be sure to clean these parts carefully.
To Next Page
Loading...
