Names of Parts and Functions
1-7
1
Before Use
3
4
5
6
Heater
Pre-heater/Print heater/Post-heater are equipped on the platen.
The Pre-heater is used for pre-heating of the media prior to printing to prevent rapid changes in temperature.
The Print-heater improves the image quality in printing.The Post-heater and drying-heater dries ink after
printing.
Carriage
The carriage is provided with the ink heads for printing.
Also, the height adjusting screw adjusting the height of head
according to the thickness of media is arranged.
( P.2-14)
• While the heater is on, the platen is very hot.When the front cover is to be opened or media is to be
replaced, lower the heater temperatures and wait until the platen temperature drops;otherwise, you
can get burned.
• When the media is to be replaced with a thin one, lower the heater temperatures and wait until the
platen temperature drops adequately.Setting a thin sheet of media while the platen is hot may cause
the media to stick to the platen or cause wrinkling or curling of the media.
To Next Page
Loading...
