MIMAKI SWJ-320 S2 - Automatic Maintenance Settings; Setting Refreshing Intervals

4-25
1
1
1
4
Routine Maintenance
Automatic Maintenance Function
To use this machine comfortably, you can set various maintenances to be performed automatically.
Here, set performing intervals of various automatic maintenances.
You can prevent troubles such as ink clogging by performing automatic maintenance periodically (automatic
maintenance function).
For the auto maintenance functions, the following items can be set:
Setting the Refreshing Intervals
The interval between each operation of ejecting a small amount of ink from the nozzles to prevent nozzle
clogging is set.
1
Select [AUTO MAINT.] of the maintenance menu.
(1) Press the key in LOCAL.
(2) Press to select [MAINTENANCE] and press the key.
(3) Press to select [AUTO MAINT.].
2
Press the key.
3
Press the key.
4
Press to set the refreshing interval.
• Set value : Lv.1, Lv.2, Lv.3
• As the LEVEL increases, the interval between each operation gets shorter.
5
Press the key.
6
Press the key several times to end the setting.
• When you perform maintenance manually, after manual maintenance is completed and when time set
with the automatic maintenance function has passed, maintenance starts automatically.
Function name Descriptions
REFRESH
The interval between each refreshing operation is set.
PUMP TUBE WASH
The interval between each PUMP tube washing operation is set.
CLEANING
The interval between each cleaning operation is set.
• During the right message is displayed, the operation set in the
auto maintenance function is not carried out. Perform the
operations of P.4-28 if required.
• When the power switch on the front of the machine is turned off,
check the waste ink tank.
<LOCAL>
Chec k was t e i n k [ MNT ]
AUTO MA I NT .
REFRESH [ ENT ]
REFRESH
:Lv.1
REFRESH .
:Lv.1
AUTO MA I NT .
REFRESH [ ENT ]