MIMAKI SWJ-320 S2 - Setting Logical Seek

3-3
1
1
3
Convenient use
5
6
Setting Logical Seek
The motion of Head varies depending on the set of Logical-seek.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [LOGICAL SEEK].
4
Press the key.
5
Press to select a set value.
• Set value : HOST / ON / MEDIA LENGTH / MACHINE LENGTH
6
Press the key.
7
Press the key several times to end the setting.
• You cannot specify the logical seek at the RasterLinkPro side. When you set this machine to “Host”,
printing will be performed in “LOGICAL SEEK=ON” status.
• When you set this to “OFF”
The time to the print completion gets longer, but no difference occurs in the drying condition
depending on the data width.
UNI-DIRECTIONAL BI-DIRECTIONAL
Movement of heads when
LOGICAL seek is OFF
Movement of heads when
LOGICAL seek is ON
UNI-DIRECTIONAL BI-DIRECTIONAL
MACHINE LENGTH MEDIA
FUNCT I ON
SETUP [ ENT [
SETUP
FEED COMP . [ ENT ]
SETUP
LOG I CAL SEEK [ ENT ]
LOG I CAL SEEK
:HOST
LOG I CAL SEEK
:OFF
SETUP
LOG I CAL SEEK [ ENT ]